Installation Guide
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the Access Point
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Attaching the Antennas to the Access Point
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Appendix A
AT-TQ5403e Outdoor Wireless Access Point Installation Guide
38
3. Using the mounting base as a template, mark four holes with a pencil.
See Figure 13.
c
Figure 13. Mounting Base Hole Dimensions
4. Pre-drill the marked locations on the wall.
5. Attach the mounting base to the access point with the screws using a
Phillips-head screwdriver. See Figure 14.
Note
Attach the ground cable to the access point before attaching the
mounting base. See “Attaching the Ground Cable to the Access
Point” on page 30.
Figure 14. Attaching the Mounting Base to the Access Point
Draft 5 on February 14, 2019