Installation Guide
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the Access Point
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Attaching the Antennas to the Access Point
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Appendix A
Chapter 2: Installing the Access Point
37
Figure 12. Two Orientations of the Mounting Base
What to Prepare
for Wall
Installation
You need the following items to install the access point on a wall:
AT-TQ5403e Access Point
Mounting base
Four screws for the mounting base
Screws for the wall, one of the following:
– Four sets of the bolt, nut, washer, and wall anchor
for a concrete wall
– Four tapping screws for a regular wall
Drill
Phillips-head screwdriver
Pencil
Note
Screws for the wall, drill, Phillip-head screwdriver, and pencil are not
included in the shipping box.
Installing the
Access Point on a
Wall
To install the access point on the wall, perform the following procedure:
1. Review “Guidelines” on page 36.
2. Orient the mounting base to the access point.
Note
The mounting base can be in a vertical or horizontal position. see
Figure 12.
Draft 5 on February 14, 2019