Installation Guide
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the Access Point
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Attaching the Antennas to the Access Point
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Appendix A
AT-TQ5403e Outdoor Wireless Access Point Installation Guide
36
Installing the Access Point on a Wall
The AT-TQ5403e access point can be mounted on a wall.
To install the access point, perform the following procedures:
Guidelines Review the following guidelines before installing the access point on a
wall:
Attach the ground cable before attaching the mounting base to the
access point.
Connect the Ethernet cable to the access point before installing the
access point on a wall or pole because connecting the Ethernet
cable is difficult after the access point is installed.
Attach the antennas to the access point before installing it on a
wall or pole because attaching the antennas is difficult after the
access point is installed.
The access point must be installed the front panel down as shown
in Figure 12.
Figure 11. Orientation of the Access Point
The mounting base can be in a vertical or horizontal position. See
Figure 12 on page 37.
Draft 5 on February 14, 2019