Installation Guide
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the Access Point
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Attaching the Antennas to the Access Point
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Appendix A
AT-TQ5403e Outdoor Wireless Access Point Installation Guide
34
Attaching the Antennas to the Access Point
To install the antennas, perform the following procedure:
1. Remove the blind caps covering the antenna connectors from the
main unit.
2. Attach a surge protector to an antenna connector. See Figure 8.
Figure 8. Attaching a Surge Protector to an Antenna Connector
3. Screw an antenna into the surge protector that you just attached to the
access point. See Figure 9.
Note
You must install 5GHz antennas to 5GHz antenna connectors and
2.4GHz antennas to 2.4GHz antenna connectors.
Figure 9. Installing an Antennas to the Surge Protector
Draft 5 on February 14, 2019