Installation Guide
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the Access Point
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Attaching the Antennas to the Access Point
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Appendix A
AT-TQ5403e Outdoor Wireless Access Point Installation Guide
32
Connecting the Access Point with the Ethernet Cable
To connect the access point with the Ethernet cable, perform the following
procedure:
1. Unscrew the cap at the LAN port to remove the cap from the access
point. See Figure 5.
Figure 5. Removing the Cap from the LAN Port
2. Store the cap in a secured place.
3. Take the sealing nut apart.
4. Pass the LAN cable through the sealing nut, and attach the sealing
insert and clamping claw to the cable. See Figure 6.
Figure 6. Applying the Sealing Parts to the LAN Cable
5. Connect the RJ-45 plug into the LAN port and screw the sealing nut to
the access point. See Figure 7 on page 33.
Draft 5 on February 14, 2019