Installation Guide
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the Access Point
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Attaching the Antennas to the Access Point
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Appendix A
Chapter 2: Installing the Access Point
31
Attaching the
Ground Cable to
the Access Point
To attach the ground cable to the access point, perform the following
procedure:
1. Align the ground cable hole on the access point with the ring terminal
of the ground cable. See Figure 4.
Note
You can select one of two ground cable holes located at the bottom
corners on the back of the access point.
Figure 4. Aligning the Access Point with Ground Cable
Note
The ground wire should be 20AWG or larger and the screw should
be 3.5mm or larger.
2. Drive the screw through the holes to attach the ground cable to the
access point.
3. Cut off the extra length of the ground cable to make it connected
straight to the ground point.
4. Attach the other terminal of the ground cable to a circuit breaker,
ground rod, or earth ground.
Draft 5 on February 14, 2019