Installation Guide
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the Access Point
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Attaching the Antennas to the Access Point
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Appendix A
Chapter 2: Installing the Access Point
25
Advertissement
Température de fonctionnement. Ce produit est conçu pour une
température ambiante maximale de 65 °C. E50
Caution
FCC Caution: Any changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate this equipment. E80
Attention
Avertissement de la FCC: tout changement ou modification non
expressément approuvé par la partie responsable de la conformité
pourrait annuler l'autorité de l'utilisateur à utiliser cet appareil.
E80
Note
All Countries: Install product in accordance with local and National
Electrical Codes. E8
Note
You should verify that your PoE network adheres to the standards of
a separated extra-low voltage (SELV) circuit before using the PoE
feature on the wireless access point.
Warning
Only trained and qualified personnel are allowed to install or to
replace this equipment. E14
Advertissement
Seul le personnel qualifié et compétent est autorisé à installer ou à
remplacer cet équipement. E14
Warning
This equipment shall be installed in a Restricted Access location.
E45
Draft 5 on February 14, 2019