Installation Guide

23
Chapter 2
Installing the Access Point
This chapter describes how to install the AT-TQ5403e access point. This
chapter contains the following sections:
 “Reviewing Safety Precautions” on page 24
 “Unpacking the Access Point” on page 27
 “Attaching the Ground Cable to the Access Point” on page 30
 “Connecting the Access Point with the Ethernet Cable” on page 32
 “Attaching the Antennas to the Access Point” on page 34
 “Installing the Access Point on a Wall” on page 36
 “Installing the Access Point on a Pole” on page 40
 “Starting the Initial Management Session on the Access Point” on
page 43
 “Setting the Country Setting” on page 45
Note
The non-US model of this product has a country code setting that
must be set during the initial management session of the unit. The
setting ensures that the unit operates in compliance with the laws
and regulations of your country or region.
For the US model, the country code is preset and cannot be
changed. Per FCC regulations, the country code setting for all WiFi
products marketed in the US must be fixed to US operational
channels only.
Draft 5 on February 14, 2019