Installation Guide
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the Access Point
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Attaching the Antennas to the Access Point
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Appendix A
AT-TQ5403e Outdoor Wireless Access Point Installation Guide
20
Reset Button
The reset button on the front panel is used to return the parameter settings
of the device to its default values. You might use the button if you want to
discard the current configuration of the device or because you forgot the
password to the manager account and cannot manage the device.
To reset the device, remove the clear cap on the front panel and press the
black button for five seconds and release. The reset button is protected to
prevent from being accidentally pressed.
By default, the reset button is disabled. To enable reset button, see a User
Guide for this access point.
Draft 5 on February 14, 2019