Installation Guide
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the Access Point
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Attaching the Antennas to the Access Point
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Appendix A
Chapter 1: Product Description
19
Automatic MDIX
Detection
The 10/100/1000 Mbps twisted-pair port is IEEE 802.3ab compliant and
features automatic MDIX detection when operating at 10 or 100 Mbps.
(Automatic MDIX detection does not apply to 1000 Mbps.) This feature
automatically configures the port to MDI or MDI-X depending on the wiring
configuration of the port on the Ethernet switch.
You may not disable automatic MDIX detection. For automatic MDIX
detection to work properly, it must also be present on the Ethernet switch.
The LAN port defaults to MDIX if it is connected to a network device that
does not support automatic MDIX detection.
Port Pinouts Refer to Table 11 on page 49 for the port pinouts of the LAN port when it is
operating at 10 or 100 Mbps in the MDI configuration and Table 12 on
page 50 for the MDI-X configuration. Refer to Table 13 on page 50 for the
port pinouts when the port is operating at 1000 Mbps.
Draft 5 on February 14, 2019