Installation Guide
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the Access Point
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Attaching the Antennas to the Access Point
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Appendix A
Chapter 1: Product Description
17
LEDs
The LEDs on the AT-TQ5403e access point are described in Table 2.
Table 2. LEDs
LED State Description
LAN Solid Green A link is established and the port is operating
normally.
Blinking
Green
Data is being transmitted/received.
Off A link is not established.
WLAN Solid Green One or more radio among Radio1, Radio2,
and Radio3 is enabled.
Off Radio1, Radio2, and Radio3 are all disabled.
Power Solid Green The unit is receiving power that is within the
normal operating range.
Blinking
Green
The access point is booting up or upgrading
the firmware.
Off The power supply is not receiving power
through the LAN port.
Draft 5 on February 14, 2019