User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
AT-TQ4400e Outdoor Wireless Access Point Installation Guide
65
LAN Port
Figure 32 illustrates the pin layout of the LAN port.
Figure 32. Pin Layout for the RJ45 Connector on the LAN Port
Table 19 lists the pin signals when the port is operating in the MDI
configuration at 10 or 100 Mbps.
Table 18. LAN Port Specifications
Connector RJ45
Standards IEEE 802.3 (10Base-T)
IEEE 802.3u (100Base-TX)
IEEE 802.3ab (1000Base-T)
PoE standard IEEE 802.3at (class 4)
Table 19. MDI Pin Signals (10Base-T or 100Base-TX)
Pin Signal
1TX+
2TX-
3RX+
6RX-
Draft 4 on November 9, 2017