User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
Chapter 4: Installing the Optional Antennas
58
4. Connect cables to the connectors on the top and back panels of the
antenna.
When you use the 2.4GHz band, see Figure 26; when you use the
5Ghz band, see Figure 27.
Figure 26. Installing Antennas for 2.4GHz to the Access Point
Figure 27. Installing Antennas for 5GHz to the Access Point
Draft 4 on November 9, 2017