User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
Chapter 4: Installing the Optional Antennas
56
Overview
In addition to the antennas that come with the AT-TQ4400e access point,
Allied Telesis supports three optional antennas.
To install one of the optional antennas, you need two cables to connect
the antenna and the access point. For more information about the cables,
see “Cables to Connect an Optional Antenna” on page 30.
To install one of the optional antennas, perform one of the following
procedures:
“Installing the AT-AN2458-10DP Mini Panel Antenna” on page 57
“Installing the AT-AN5158-16DP Sector Antenna” on page 59
“Installing the AT-AN5158-19DP Flat Panel Antenna” on page 61
Draft 4 on November 9, 2017