User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
Chapter 3: Installing the Access Point
48
Attaching the Antennas to the Access Point
In addition to the antennas that came with the access point, Allied Telesis
supports three optional antennas.
Note
To install the optional antennas, see Chapter 4, “Installing the
Optional Antennas” on page 55.
To install the antennas that is shipped with the access point, perform the
following procedure:
1. Screw a 5GHz antenna into the 5GHz antenna connector on the top
panel of the access point. See Figure 21.
Figure 21. Installing Antennas to the Access Point
2. Repeat Step 1 for the second 5GHz antenna to screw into the 5GHz
antenna connector on the bottom panel of the access point.
3. Screw a 2.4GHz antenna into the 2.4GHz antenna connector on the
top panel of the access point. See Figure 21.
4. Repeat Step 3 for the second 2.4GHz antenna to screw into the
2.4GHz antenna connector on the bottom panel of the access point.
Draft 4 on November 9, 2017