User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
Chapter 3: Installing the Access Point
46
Note
Attach the ground cable to the access point before attaching the
mounting base to the access point. See “Attaching the Ground
Cable to the Access Point” on page 37.
3. Orient the pole-mount bracket for installing to either a vertical pole or a
horizontal pole. See Figure 19.
Figure 19. Attaching the Pole-Mount Bracket to the Mounting Base
4. Drive the screws to attach the pole-mount bracket to the mounting
base using a Phillips-head screwdriver.
5. Attach the O-ring clamp to the pole-mount bracket. See Figure 20.
Figure 20. Attaching the O-Ring Clamp to the Pole-Mount Bracket
6. Install the unit to the pole and tighten the O-ring clamp using the flat-
head screwdriver.
Installing to a Vertical Pole
Installing to a Horizontal Pole
Installing to a Vertical Pole Installing to a Horizontal Pole
Draft 4 on November 9, 2017