User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
AT-TQ4400e Outdoor Wireless Access Point Installation Guide
43
Figure 15. Attaching the Mounting Base to the Access Point
5. Install the four sets of bolts and wall anchors into the holes you made
in Step 3.
6. Attach the nuts and washers to the bolts in the concrete wall to install
the access point. See Figure 16.
Figure 16. Installing to the Wall Using Bolts
7. Proceed to “Attaching the Antennas to the Access Point” on page 48.
Draft 4 on November 9, 2017