User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
Chapter 3: Installing the Access Point
42
Installing the
Access Point on a
Concrete Wall
To install the access point on the wall, perform the following procedure:
1. Review “Guidelines” on page 41.
2. Using the mounting base as a template, mark four holes with a pencil.
See Figure 14 on page 42 for hole dimensions.
Figure 14. Base Plate Hole Dimensions
3. Pre-drill the marked locations on the concrete wall.
4. Attach the mounting base to the access point with the screws using a
Phillips-head screwdriver, as shown in Figure 15.
Note
Attach the ground cable to the access point before attaching the
mounting base. See “Attaching the Ground Cable to the Access
Point” on page 37.
Draft 4 on November 9, 2017