User's Manual

AT-TQ4400e Outdoor Wireless Access Point Installation Guide
41
Installing the Access Point on a Wall
The AT-TQ4400e access point can be mounted on a concrete or regular
wall. To install the access point, perform one of the following procedures:
 “Installing the Access Point on a Concrete Wall” on page 42
 “Installing the Access Point on a Regular Wall” on page 44
Guidelines Review the following guidelines before installing the access point on a
wall:
 Attach the ground cable before attaching the mounting base to the
access point.
 Connect the Ethernet cable to the access point before installing the
access point on a wall or pole if connecting the Ethernet cable will
be difficult after the access point is installed.
 Attach the antennas to the access point before installing it on a wall
or pole if attaching the antennas will be difficult after the access
point is installed.
 If you are not installing the access point on a concrete wall, provide
four tapping screws. They are not included in the shipping box.
What to Prepare
for Wall
Installation
You need the following items to install the access point on a wall:
 AT-TQ4400e Access Point
 Mounting base
 Four screws for the mounting base
 Screws for the wall, one of the following:
– Four sets of the bolt, nut, washer, and wall anchor
for a concrete wall
– Four tapping screws for a regular wall
 Drill
 Phillips-head screwdriver
 Pencil
Note
Screws fro the wall, drill, Phillip-head screwdriver, and pencil are not
included in the shipping box.
Draft 4 on November 9, 2017