User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
Chapter 3: Installing the Access Point
40
Figure 12. Applying the Sealing Parts to the LAN Cable
4. Connect the RJ-45 plug into the LAN port and screw the sealing nut to
the access point as shown in Figure 13.
Figure 13. Connecting the LAN Cable and Attaching the Sealing Nut
5. Connect the other RJ-45 plug to the PoE switch.
Draft 4 on November 9, 2017