User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
AT-TQ4400e Outdoor Wireless Access Point Installation Guide
39
Connecting the Access Point with the Ethernet Cable
To connect the access point with the Ethernet cable, perform the following
procedure:
1. Unscrew the sealing nut at the LAN port on the access point and
remove the clamping claw and sealing insert. See Figure 10.
Figure 10. Removing the Sealing Nut, Clamping Claw, and Sealing Insert
2. Remove the rubber nail from the sealing insert. See Figure 11.
Figure 11. Removing the Rubber Nail from the Sealing Insert
3. Pass the LAN cable through the sealing nut, and attach the sealing
insert and clamping claw to the cable as shown in Figure 12 on page
40.
Draft 4 on November 9, 2017