User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
Chapter 3: Installing the Access Point
34
Unpacking the AT-TQ4400e Access Point
To unpack the AT-TQ4400e access point, perform the following
procedure:
1. Remove all components from the shipping boxes.
Note
Store the packaging material in a safe location. You must use the
original shipping material if you need to return the unit to Allied
Telesis.
2. Verify that all components listed in Table 14 are included in your
shipping boxes.
Table 14. Components in the Shipping Boxes
Name Component
2 x 5GHz Antenna
2 x 2.4GHz Antenna
Mounting Base
Draft 4 on November 9, 2017