User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
Chapter 2: Optional Antennas and Cables
30
Cables to Connect an Optional Antenna
To connect the optional antenna and the AT-TQ4400e access point, you
need to use one of the following cables:
AT-AN0001 RF Coax Cable
AT-AN0002 RF Coax Cable
AT-AN0003 RF Coax Cable
Note
You need two cables to connect the optional antenna and the
access point.
Cable
Specifications
Here are the descriptions and specifications of the cables.
Table 13 shows the descriptions and specifications of the cables.
4
Table 13. Cable Descriptions and Specifications
Cable Model Connector Calbe Diameter Length
AT-AN0001 N-male to N-male 0.24 in. (6.1mm) 4.0 ft. (1.2m)
AT-AN0002 N-male to N-male 0.41 in. (10.3mm) 10.0 ft. (3.0m)
AT-AN0003 N-male to N-male 0.41 in. (10.3mm) 20.0 ft. (6.1m)
Draft 4 on November 9, 2017