User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
AT-TQ4400e Outdoor Wireless Access Point Installation Guide
29
Electrical Specifications
Table 11 shows the electrical specifications for the Flat Panel Antenna.
Mechanical Specifications
Table 12 shows the mechanical specifications for Flat Panel Antenna.
Table 11. Electrical Specifications for the Flat Panel Antenna
Item Value
Frequency Range 4900-5850 MHz
Gain 19 dBi
Polarization Vertical and Horizontal
Maximum Voltage Standing Wave Ratio
(VSWR)
<1.8
V Polarization Horizontal Beamwidth 86°
H Polarization Horizontal Beamwidth 75°
Vertical Beamwidth 23°
Front to Back Ratio ≥25 dB
Cross Polarization Isolation > 28 dB
Maximum Input Power 10 watts
Input Impedance 50Ohm
Lightning Protection DC Ground
Table 12. Mechanical Specifications for the Flat Panel Antenna
Item Description
Connector Interface N-Female x 2
Radome Material Gray ASA (acrylic ester-styrene-acrylonitrile)
Dimensions 12.40 x 12.40 x 0.98 in.(315 x 315 x 25 mm)
Weight including the
bracket
3.5 lbs (1.6kg)
Mounting Mast Size
(diameter)
0.75-2.00 in. (19-50 mm)
Rated Wind Velocity 130 mph/h (210 km/h)
RoHS Compliant Yes
Draft 4 on November 9, 2017