User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
Chapter 2: Optional Antennas and Cables
28
AT-AN5158-
19DP Flat Panel
Antenna
The AT-AN5158-19DP Flat Panel Antenna combines vertical and
horizontal polarization with high gain over a broadband frequency in a
single enclosure. It operates in the 4.9 to 5.8 GHz frequency bands. See
Figure 7.
Figure 7. AT-AN5158-19DP Flat Panel Antenna
The Flat Panel Antenna is fed via two N-female ports, one for the vertically
polarized signal and one for the horizontally polarized signal.
The Antenna is supplied with a mast mount kit. It allows the antenna to be
mounted to a 0.75 inch (19 mm) to 2 inch (50 mm) diameter mast and
adjusted upward up to 60° and downward to 10°. See Figure 8.
Figure 8. AT-AN5158-19DP Flat Panel Antenna Adjustment
Features
UV-resistant radome for all-weather operations
Dual polarity feed system in single enclosure
MIMO: Multiple Input and Multiple Output
Draft 4 on November 9, 2017