User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
AT-TQ4400e Outdoor Wireless Access Point Installation Guide
15
Figure 3. AT-TQ4400e Access Point Side Panel
The components are listed in Table 1.
Note
Do not remove the Gore® vent plug from the access point.
Table 1. Components of the Access Point
Component Description
5 GHz Antenna
Connector
N-type female connector for the 5 GHz
antenna
2.4 GHz Antenna
Connector
N-type female connector for the 2.4 GHz
antenna
LAN 1 Port (PoE Input) The LAN port connects the access point to
your wired network. It supports PoE+. The
PoE+ capable LAN port is the only way to
supply power to this access point. You must
connect this LAN port to a PoE switch.
Gore® vent The vent equalizes housing pressures,
protects against dirt, dust, humidity and
water, and reduces condensation.
Gore® vent
Draft 4 on November 9, 2017