User's Manual
Table Of Contents
- Contents
- Figures
- Tables
- Preface
- Chapter 1
- Overview
- Chapter 2
- Installing the Access Point
- Appendix A
- Technical Specifications
- Appendix B
- Regulatory Statements
Chapter 2: Installing the Access Point
34
Figure 9. Wall Orientations
You may not install the access point upside down on a wall.
The location must have an AC power source if you are using the AT-
TQ0091 Power Adapter.
If the LAN cable is external to the wall, you must route the cable
through the notch in the rear panel of the cover. If the cable is internal
to the wall, you may route it either through the notch in the cover or
through the hole in the bottom panel.
You must not route the LAN cable inside the access point such that it
touches the heat sinks because that could damage the unit. Refer to
Figure 10 on page 35.
Review Draft - January 24, 2014