User's Manual

Chapter 2: Installing the Access Point
30
Figure 4. Connecting the Network Cable for Table or Desktop Installation
4. If you have not already done so, connect the other end of the network
cable to a port on an Ethernet switch.
5. Do one of the following:
 If the access point is to be powered with the AT-TQ0091 AC/DC Power
Adapter, continue with this procedure to attach the power adapter.
 If the access point is to be powered with the PoE feature on the LAN
Port, turn the access point right side up. The installation procedure is
complete. Go to “Installing Anti-theft Devices” on page 50 or “Starting
the Initial Management Session on the Access Point” on page 51.
6. Route the DC power cable from the AT-TQ0091 AC/DC Power
Adapter through the notch in the cover and under the bottom panel,
and connect it to the DC-IN connector on the access point. Refer to
Figure 5 on page 31.
Review Draft - January 24, 2014