User's Manual

Chapter 2: Installing the Access Point
48
Figure 27. Securing the DC Power Cord to the AT-BRKT-J26 Bracket with
the Tie Wrap
13. Connect the AC plug on the power cord to an appropriate AC power
source. Refer to Table 8 on page 54 for the power specifications of the
power adapter.
Note
Do not perform step 8 if your network has a DHCP server and you
want to configure it before powering on the access point. The
access point is identified by the DHCP server by its MAC address,
which is found on a label on the bottom panel of the unit.
After installing the access point, go to “Starting the Initial Management
Session on the Access Point” on page 50.
CONSOLE PORT
RESET
5GHz
RESET
2.4GHz
LAN
10BASE-T/100BASE-TX/1000BASE-T
(AUTO MDI/MDI-X)
PoE IN
12VDC
2.4GHz
5GHz
Anchors
Review Draft - March 18, 2012