User's Manual
Table Of Contents
- Contents
- Figures
- Tables
- Preface
- Chapter 1
- Overview
- Chapter 2
- Installing the Access Point
- Appendix A
- Technical Specifications
- Appendix B
- Regulatory Statements
Chapter 2: Installing the Access Point
46
8. Connect the other end of the network cable to a port on an Ethernet
switch.
9. If you are not using the PoE feature on the Ethernet port to power the
unit, continue with this procedure to attach the AC/DC power adapter.
Note
If you are using the PoE feature to power the access point, the
installation procedure is complete. Go to “Starting the Initial
Management Session on the Access Point” on page 50.
10. Connect the power cord to the AC/DC adapter. Refer to Figure 25.
Figure 25. Connecting the Power Cord to the AC/DC Adapter
11. Connect the DC cable on the AC/DC adapter to the 12VDC connector
on the access point. Refer to Figure 26 on page 47.
Review Draft - March 18, 2012