User's Manual

AT-TQ2450 Installation Guide
41
Figure 18. Rear Panel Upside Down
2. Locate the two screw holes on the rear panel. The holes are used to
secure the top panel to the access point. Refer to Figure 19.
Figure 19. Screws Holes for Securing the Top Panel to the Access Point
3. Lower the top panel over the access point as shown in Figure 20 on
page 42 and secure it by tightening the two retaining screws into the
two corresponding holes on the rear panel of the access point.
CONSOLE PORT
RESET
5GHz
RESET
2.4GHz
LAN
10BASE-T/100BASE-TX/1000BASE-T
(AUTO MDI/MDI-X)
PoE IN
12VDC
CONSOLE PORT
RESET
5GHz
RESET
2.4GHz
LAN
10BASE-T/100BASE-TX/1000BASE-T
(AUTO MDI/MDI-X)
PoE IN
12VDC
Screw Holes
Review Draft - March 18, 2012