User's Manual
Table Of Contents
- Contents
- Figures
- Tables
- Preface
- Chapter 1
- Overview
- Chapter 2
- Installing the Access Point
- Appendix A
- Technical Specifications
- Appendix B
- Regulatory Statements
AT-TQ2450 Installation Guide
37
Figure 13. Flange on the Bottom Panel of the AT-BRKT-J26 Bracket
You should verify that the wall or ceiling material is strong enough to
support the weight of the bracket and access point.
If you will not be using the PoE feature, there needs to be an AC power
source near the place chosen for the access point.
You have to provide the four screws and, if necessary, the wall
anchors, that are used to secure the bottom panel to the wall or ceiling.
The base panel has eight screw holes. Refer to Figure 14 on page 38.
The holes are grouped in pairs. The unit should be secured to the wall
or ceiling with a minimum of four screws. You may use either screw
hole in a pair to secure the panel.
Flange
Review Draft - March 18, 2012