User's Manual

AT-TQ2450 Installation Guide
35
Figure 11. Securing the DC Power Cord to the Access Point with the Tie
Wrap
8. Connect the AC plug on the power cord to an appropriate AC power
source. Refer to Table 8 on page 54 for the power specifications of the
power adapter.
Note
Do not perform step 8 at this time if your network has a DHCP server
and you want to configure it before powering on the access point.
The access point is identified by the DHCP server by its MAC
address, which is found on a label on the bottom panel of the unit.
After installing the access point on the table, go to “Starting the Initial
Management Session on the Access Point” on page 50.
CONSOLE PORT
RESET
5GHz
RESET
2.4GHz
LAN
10BASE-T/100BASE-TX/1000BASE-T
(AUTO MDI/MDI-X)
PoE IN
2.4GHz
5GHz
12VDC
Review Draft - March 18, 2012