User's Manual

AT-TQ2450 Installation Guide
33
Figure 8. Attaching the Network Cable to the LAN Port
4. Connect the other end of the network cable to a port on an Ethernet
switch.
If you are not using the PoE feature on the Ethernet port to power the
unit, continue with this procedure to attach the AC/DC power adapter.
Note
If you are using the PoE feature on the LAN Port to power the
access point, the installation procedure is complete. Go to “Starting
the Initial Management Session on the Access Point” on page 50.
5. Connect the power cord to the AC/DC adapter. Refer to Figure 9.
Figure 9. Connecting the Power Cord to the AC/DC Adapter
CONSOLE PORT
RESET
5GHz
RESET
2.4GHz
LAN
10BASE-T/100BASE-TX/1000BASE-T
(AUTO MDI/MDI-X)
PoE IN
12VDC
2.4GHz
5GHz
Review Draft - March 18, 2012