User's Manual

Chapter 2: Installing the Access Point
32
Installing the Access Point on a Table
To install the access point on a table, perform the following procedure:
1. Place the access point upside down on a table.
2. Affix the four rubber feet included with the access point to the four
corners of the bottom panel of the unit. Refer to Figure 6.
Figure 6. Installing the Rubber Feet
1. Turn the access point right side up on the table.
2. Install the three 2.4 GHz and three 5 GHz antennas to the
corresponding connectors on the sides of the unit. The connectors are
labelled. Refer to Figure 7.
Figure 7. Installing the Antenna
3. Attach a network cable to the LAN port. Refer to Figure 8 on page 33.
CONSOLE PORT
RESET
5GHz
RESET
2.4GHz
LAN
10BASE-T/100BASE-TX/1000BASE-T
(AUTO MDI/MDI-X)
PoE IN
12VDC
2.4GHz
5GHz
Review Draft - March 18, 2012