Installation Guide

AT-TQ1402 Series Wireless Access Point Installation Guide
49
LAN Port Specifications and Pinouts
Port
Specifications
The AT-TQ1402 Series Access Point port specifications are shown in
Table 10.
Port Pinouts The pin signal definitions for 10/100/1000 Mbps Ethernet traffic are as
follows.
Figure 19 illustrates the pin layout of the LAN ports.
Figure 19. Pin Layout for RJ45 Connector on LAN Port
Table 11 lists the pin signals when the port is operating in the MDI
configuration at 10/100 Mbps.
Table 10. LAN Port Specifications
Connector Specification
Standards - LAN IEC603-7 (10/100/1000 Base T)
PoE standard - LAN IEEE 802.3af (class 3)
Table 11. MDI Pin Signals (10Base-T or 100Base-TX)
Pin Signal
1 TX+
2 TX-
3 RX+
6 RX-