Installation Guide

Chapter 2: AT-TQ1402 Series Wireless Access Point Installation
44
Start Initial Management Session
This section contains an abbreviated version of the procedure to start the
initial management session. For complete instructions, refer to the
AT-TQ1402 Series Wireless Access Point Series User’s Guide.
The wireless access point firmware includes a DHCP client. The default
setting for the client is enabled. When you power on the access point for
the first time, it queries the subnet on the LAN port for a DHCP server. If a
DHCP server responds to its query, the unit uses the IP address the
server assigns to it. If there is no DHCP server, the access point uses the
default IP address 192.168.1.230.
To start the initial management session, perform the following procedure:
1. Start the web browser on your management workstation.
2. Enter the IP address of the wireless access point in the URL field of
the web browser. The address is one of the following:
 If your network does not have a DHCP server, enter the default
address 192.168.1.230.
 If your network has a DHCP server, enter the IP address the
DHCP server assigned to the access point.
The wireless access point displays the logon prompt. Refer to
Figure 18.
Figure 18. Logon Prompt
3. Enter “manager” for the username and “friend” for the password. The
username and password are case-sensitive.
TQ1402