Installation Guide

Chapter 2: AT-TQ1402 Series Wireless Access Point Installation
42
2. If you are installing your AT-TQ1402 Series on a table top surface,
your unit is now ready for use.
3. If you are installing your AT-TQ1402 Series on the ceiling or wall
installation, go to “Ceiling or Wall - Attach Chassis to Mounting
Bracket” on page 42 section.
Ceiling or Wall -
Attach Chassis to
Mounting
Bracket
Perform this procedure to complete the ceiling or wall installation by
attaching the chassis to the mounting bracket.
1. Align and insert the two access point chassis screws into the keyhole
slots of the mounting bracket. Refer to Figure 15.
Note
These are the same two access point chassis screws that you
previously installed in the procedure “Ceiling or Wall - Mounting
Bracket Installation” on page 35.
Figure 15. Align/Insert Access Point into Mounting Bracket
2. Slide the chassis forward until seated into the bracket keyhole slot and
the bracket thumbscrew is aligned with the screw hole on the front of
the chassis. Refer to Figure 16 on page 43.
4692
5GHz
2.4GHz
PWR
LAN
AT-TQ1402
Ceiling
Wall
4689