Installation Guide

AT-TQ1402 Series Wireless Access Point Installation Guide
41
2. Plug the DC plug of the Power Adapter into the DC-IN jack on the
access point. Refer to Figure 13.
Figure 13. Connect External AC/DC Power Adapter Cable
3. Connect the external power supply AC plug to an appropriate AC
power source.
4. On the AT-TQ1402 Series chassis, push the DC Power Button to the
“IN” position to turn ON the power supply at the chassis.
Note
The DC Power Button controls power to the DC-IN jack only. PoE
power provided on the LAN port is not affected by this button.
5. Go to the ”Install Anti-theft Device” section.
Install Anti-theft
Device
Installation of an anti-theft cable/lock is optional. If you choose to install a
physical security device, the AT-TQ1402 Series has a lock port that is
compatible with a Kensington lock. The lock port can be used to physically
secure the device when it is installed on a table, wall, or a ceiling.
Note
Anti-theft devices including a Kensington lock are not available from
Allied Telesis.
1. Follow the instructions provided with the vendor’s anti-theft device
packaging for the installation. Refer to Figure 14 for the Kensington
lock port location.
Figure 14. Kensington Lock Port Location
POE
4693
LAN CONSOLEDC INPOWER RESET
4697
Kensington
Lock Port