Installation Guide

Chapter 2: AT-TQ1402 Series Wireless Access Point Installation
40
Install Ethernet
Cable and
External DC
Power Supply
The Ethernet and power cable needs to be connected before attaching the
access point to the mounting bracket.
Note
Refer to “Cable Specifications” on page 48 when selecting Ethernet
cable.
1. Connect the Ethernet cable into the RJ-45 LAN port. Refer to
Figure 12. This Ethernet port is capable of receiving PoE power.
Figure 12. Connect Ethernet Cable to LAN Port
2. Connect the opposite end of the Ethernet cable to your network
Ethernet device.
Note
If you plan to use PoE power as the primary or redundant power
source, then the Ethernet device connected to the LAN port needs
to be capable of providing PoE power. For the PoE input power
specifications, refer to “PoE Power Requirements” on page 47.
3. Depending on the primary power source for the AT-TQ1402 Series
Access Point, perform one of the following steps:
a. If the access point is to be powered with the PoE feature only, then
the PoE power source is already connected via the Ethernet cable
connected to LAN. Go to “Install Anti-theft Device” on page 41.
b. If the primary power for the access point is to be an external
AC/DC power supply, proceed to ”External AC/DC Power Adapter
Installation”.
External AC/DC
Power Adapter
Installation
If you choose to use an external AC/DC power supply, Allied Telesis
recommends that you procure an AT-MWS0091 Power Adapter by
contacting your local Allied Telesis representative.
Perform the following procedure to install the external power supply:
1. Check the AC plug on the external power supply and verify that it is the
correct plug for your region. If it is not, follow the instructions provided
with the external power supply to install the correct AC plug that is
compatible with your region.
POE
4696
LAN CONSOLEDC INPOWER RESET