Installation Guide

AT-TQ1402 Series Wireless Access Point Installation Guide
37
3. Tighten the screws so that they touch the mounting bracket plate and
then loosen them by approximately 1/4 turn.
Note
Adjust the access point chassis screws so they are loose enough to
slide into the narrow end of the mounting bracket keyhole, but tight
enough to be hold the access point close without rattling against the
mounting bracket.
4. Slide the mounting bracket forward and temporarily remove it from the
access point chassis so the bracket can be independently mounted on
the ceiling or wall in the next steps. Refer to Figure 7.
Figure 7. Remove Mounting Bracket From Access Point
Install Mounting Bracket on Ceiling or Wall
1. Choose an allowable orientation of the access point from the examples
shown in Figure 4 on page 33.
Ensure that the thumb screw on the mounting bracket is oriented in the
same direction as the front of the access point chassis so that the
intended orientation of the chassis is achieved after installation.
4688
POE
LA1 CONSOLE
DC IN
POWER
RESET