Installation Guide

Chapter 2: AT-TQ1402 Series Wireless Access Point Installation
36
Pre-Fit Mounting Bracket on AT-TQ1402 Series Access Point
To pre-fit the access point on the mounting bracket, perform the following
procedure:
1. Install the two screws (provided) in the bottom side of the access point
chassis. Refer to Figure 5.
Figure 5. Attach Screws to Access Point Chassis
2. Align and insert the two screws installed in Step 1 into the mounting
bracket keyholes. Refer to Figure 6.
Figure 6. Adjust Screws on Access Point
4686
POE
LA1 CONSOLE
DC IN
POWER
RESET
4687
POE
LA1 CONSOLE
DC IN
POWER
RESET