Installation Guide

AT-TQ1402 Series Wireless Access Point Installation Guide
35
3. The installation of your AT-TQ1402 Series Access Point on the table
top surface is now complete.
Ceiling or Wall -
Mounting
Bracket
Installation
This section explains how to install the access point on a ceiling or wall
that consists of a hard surface. The following topics are included:
 “Preparation for Ceiling or Wall Installation” on page 35
 “Pre-Fit Mounting Bracket on AT-TQ1402 Series Access Point” on
page 36
 “Install Mounting Bracket on Ceiling or Wall” on page 37
 “External AC/DC Power Adapter Installation” on page 40
 “Install Anti-theft Device” on page 41
 “Ceiling or Wall - Attach Chassis to Mounting Bracket” on page 42
Preparation for Ceiling or Wall Installation
You need the following items to install the access point on a ceiling or wall:
 AT-TQ1402 Series Access Point
 Two screws to attach to the access point to mounting bracket
 Mounting bracket
 Four (4) M4, 25.0 mm flat-head wood screws and optional anchors
(not provided) for fastening the mounting bracket
 Phillips head screwdriver (not provided)
 Pencil (not provided)
 External AC/DC power supply (optional and not provided - Allied
Telesis recommends the AT-MWS0091 AC/DC Power Adapter)
 Kensington Lock (optional and not provided)
Note
The four Phillips head M4 screws/anchors, the Phillips head
screwdriver, pencil, external AC/DC power supply and Kensington
Lock are not included in the shipping box.