Installation Guide

Chapter 2: AT-TQ1402 Series Wireless Access Point Installation
34
Install Access Point
This section contains the following topics:
 “General Installation Guidelines” on page 34
 “Table Top Installation” on page 34
 “Ceiling or Wall - Mounting Bracket Installation” on page 35
 “Install Ethernet Cable and External DC Power Supply” on page 40
 “External AC/DC Power Adapter Installation” on page 40
 “Install Anti-theft Device” on page 41
 “Ceiling or Wall - Attach Chassis to Mounting Bracket” on page 42
General
Installation
Guidelines
The AT-TQ1402 Series Access Point can be mounted on a table, wall, or
hard-surface celling. The general installation guidelines are as follows:
 Read “Review Safety Precautions” on page 30.
 Review “Installation Guidelines” on page 33.
 Select a location where both the power and Ethernet cable will
reach the power source and the partner Ethernet device.
Table Top
Installation
This section outlines the table top installation procedure.
Preparation for Table Top Installation
You need the following items to install the AT-TQ1402 Series Access
Point on a table top:
 AT-TQ1402 Series Access Point
 One Ethernet cable - See “Cable Specifications” on page 48
 External AC/DC power supply (optional and not provided - Allied
Telesis recommends the AT-MWS0091 AC/DC Power Adapter)
 Kensington Lock (optional and not provided)
Table Top Installation Procedure
Perform the following steps for the table top installation:
1. Go to “Install Ethernet Cable and External DC Power Supply” on
page 40.
2. If you choose to install a security cable to the AT-TQ1402 Series
Access Point, go to “Install Anti-theft Device” on page 41.