Installation Guide

AT-TQ1402 Series Wireless Access Point Installation Guide
31
Warning
This equipment shall be installed in a Restricted Access location.
 E45
Warning
FCC Caution: Any changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate this equipment.  E80
Note
The AT-TQ1402 Series must be supplied by:
1. A UL Listed external AC/DC power supply suitable for use at
Tma 45
o
C, a maximum operating altitude of 3000 m or higher, and
whose output meets separated extra-low voltage (SELV), limited
power sources (LPS) and is rated 12 VDC, 2.0 A,
OR
2. By Power over Ethernet through an UL Listed ITE. Refer to
Table 7, “External Power Supply Specifications” on page 46.