Installation Guide

Chapter 1: Product Description
26
LEDs
The LEDs on the AT-TQ1402 Series Access Point top panel display the
status information. This LED display status information is given in Table 2.
Table 2. LED Status Information
LED State Description
Power
(PWR)
GREEN AT-TQ1402 Series is powered ON and
operating normally.
AMBER System is booting up.
OR
A fault condition has been detected.
BLINKING AMBER The firmware is upgrading.
OFF AT-TQ1402 Series is not receiving
power.
LAN
(PoE)
GREEN A valid link is established on the port.
BLINKING GREEN Data is being transmitted and received.
OFF No link is established.
2.4GHz
Wi-Fi
GREEN The 2.4GHz Wi-Fi interface is enabled.
OFF The 2.4GHz Wi-Fi interface is disabled.
5 GHz
Wi-Fi
GREEN The 5GHz Wi-Fi interface is enabled.
OFF The 5GHz Wi-Fi interface is disabled.