Installation Guide
Table Of Contents
Chapter 1: Product Description
22
Features
This section lists the main features of the AT-TQ1402 Series Wireless
Access Point.
Hardware
Features
The hardware features are as follows:
One fixed 10/100/1000 BASE-T port (RJ-45) in dual function mode
to support IEEE standard 802.3af compliance powered device
(PD) mode of PoE. Based on parallel 12 DC in power plane from
PD power and DC-IN power source, and the power source
supplies to AP from PoE and external power supply unit (PSU) in
parallel.
Above RJ-45 ports are half- and full-duplex-compliant under IEEE
standards 802.3x and 802.3z. The port auto-negotiates wire
speed, duplex, and MDI/MDIX settings.
2x2 2.4 GHz + 2x2 5 GHz internal antennas.
One Reset Button for Device Reboot or Reset to Default functions.
One Power Jack for the supplied power source from the Power
Adapter.
One Ejector Push Button which is the hardware Power on/off
switch only for the Power Adapter.
Built-in one 16 MB SPI NOR flash and 128 MB DDR2 memory.
Supports three single-color LEDs (i.e., LAN, 2.4 GHz, 5 GHz).
Support one dual color LED (i.e., Power LED).
2.4 GHz band Frequency Range: 2412 – 2484 MHz.
5 GHz band Frequency Range: 5150 - 5250MHz, 5725-5850MHz.
IEEE802.11a/b/g/n/ac.
2.4 GHz 2x2 MIMO 20/40 MHz Bandwidth.
5 GHz 2x2 MIMO 20/40/80 MHz Bandwidth.
IEEE802.11ac function: downlink MU-MIMO, TX beamforming.
One Kensington lock port.
One RS232 RJ-45 port for software management console function
(factory use only).
Ceiling, Wall, or table top installation.