Owner manual

SwitchBlade x3106 Installation Guide
155
6. Connect the fiber optic cable to the port on the transceiver, as shown
in Figure 109. The connector should snap into the port.
Figure 109. Attaching a Fiber Optic Cable to an XFP Transceiver in the
AT-SBx31XZ4 Line Card
7. Repeat this procedure to install additional XFP transceivers.
After installing and cabling the XFP transceivers in the AT-SBx31XZ4 Line
Cards, do one of the following:
 To install and cable additional transceivers, go to the appropriate
section in this chapter for instructions.
 After cabling all the ports in the chassis, go to Chapter 7,
“Powering On the Chassis” on page 159.