user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
351
Note
Do not activate MSTP on the AT-GS950/48PS switch without first
familiarizing yourself with the following concepts and guidelines. Like
STP and RSTP, you must activate this MSTP protocol on a switch and
then configure the protocol parameters.
Note
The implementation of MSTP in the management software complies
fully with the new IEEE 802.1s standard and should be interoperable
with any other vendor’s fully compliant 802.1s implementation.