user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
333
Caution
If you are uploading a configuration file, the file will be implemented
immediately after download. A short interruption in network service
will be experienced while the new configuration file is loaded.
Note
If the IP address contained in the new configuration file is different
than the one you currently have in your browser URL, you will loose
connectivity with the AT-S111 Management software on the
AT-GS950/48PS switch after the new configuration file is loaded. If
this is the case, you can identify the new IP address by using the ATI
Web Discovery Tool. See“DHCP and ATI Web Discovery Tool” on
page 46 for more information.
Configuration
File Download
To download an AT-S111 configuration file to your PC, perform the
following procedure:
1. Enter the IP address of the TFTP server in the field next to the TFTP
Server IP parameter.
2. Enter the name of the configuration file in the field next to the Config
File Name parameter.
3. Select the Download button.
The Results page is displayed indicating that the file has been
successfully downloaded. See Figure 129 on page 330.
4. Click on the “Return to previous page” link.